The Belkin F9K1115 v2 router has Gigabit WiFi, 4 N/A ETH-ports and 0 USB-ports.
It is also known as the Belkin AC1750 DB Wi-Fi Dual-Band AC+ Gigabit Router (F9K1115V2. It also supports custom firmwares like: OpenWrt, LEDE Project
Belkin F9K1115 v2 default Password , Login & Gateway settings :
Default Gateway IP: 192.168.2.1
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.2.1
How to factory reset (hard reset) Belkin F9K1115 v2 :
You can factory reset your Belkin F9K1115 v2 in the following way(s)
1. When the router is on, press the button reset and hold for 30 seconds.
2. While holding down the button reset, turn off the power of the router and hold down the button reset for 30 seconds
3. While holding down the button reset, turn on the power to the unit again and hold for another 30 seconds
Belkin F9K1115 v2 router specifications :
RAM: 128 MiB
Flash: 16 MiB
Custom firmwares: OpenWrt, LEDE Project
WiFi: Gigabit (abgn+ac)
2.4GHz & 5GHz
WiFi throughput: n/a
1 x N/A port
4 x N/A ports
F9K1115 v2 Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Belkin F9K1115 v2
Flashing OpenWrt on the Belkin F9K1115 v2
The Belkin F9K1115 v2 is supported by OpenWrt according to their Table of
flashing OpenWrt onto it should be quite straigthforward.
We couldn’t find any specific instructions for flashin OpenWrt on the Belkin
F9K1115 v2, but since it’s listed in their Table of Hardware as supported, you can
over to the
OpenWrt install instructions and read on there.
Note: Flashing custom firmwares is always on you’re on own risk. Make sure to
read OpenWrt’s wikis to understand the risks and how to proceed if something goes
Flashing LEDE Project on the F9K1115 v2
The Belkin F9K1115 v2 is also supported by the LEDE Project.
To install LEDE aquire the correct firmware from their
Firmware downloads page and
then follow the instructions on their
Quick Start Guide
Note: Make sure to read the LEDE wikis carefully before flashing.