The Belkin WeMo Smart Switch (F7C027) router has 300mbps WiFi, N/A ETH-ports and 0 USB-ports.
Belkin WeMo Smart Switch (F7C027) default Password , Login & Gateway settings :
If you have performed a reset of your WeMo Smart Switch (F7C027) device or not changed the defaults, you
should
be able to access it with the following settings
Default Network name (SSID): WeMo.XXX
Default subnet mask: 255.255.255.0
How to factory reset (hard reset) Belkin WeMo Smart Switch (F7C027) :
You can factory reset your Belkin WeMo Smart Switch (F7C027) in the following way(s)
1. When the router is on, press the button reset and hold for 30 seconds.
2. While holding down the button reset, turn off the power of the router and hold down the button reset for 30 seconds
3. While holding down the button reset, turn on the power to the unit again and hold for another 30 seconds
Belkin WeMo Smart Switch (F7C027) router specifications :
System specs
CPU: n/a
RAM: 32 MiB
Flash: 16 MiB
Custom firmwares: OpenWrt
Connectivity
WiFi: 300mbps (bgn)
WiFi bands
2.4GHz
WiFi throughput: n/a
WAN
None
ETH
None
USB-ports: 0
WeMo Smart Switch (F7C027) Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
secure
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
flashing
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
increase
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Belkin WeMo Smart Switch (F7C027)
Flashing OpenWrt on the Belkin WeMo Smart Switch (F7C027)
The Belkin WeMo Smart Switch (F7C027) is supported by OpenWrt according to their Table of
Hardware. So
flashing OpenWrt onto it should be quite straigthforward.
We couldn’t find any specific instructions for flashin OpenWrt on the Belkin
WeMo Smart Switch (F7C027), but since it’s listed in their Table of Hardware as supported, you can
head
over to the
OpenWrt install instructions and read on there.
Note: Flashing custom firmwares is always on you’re on own risk. Make sure to
read OpenWrt’s wikis to understand the risks and how to proceed if something goes
wrong.
Belkin stock firmware for the WeMo Smart Switch (F7C027)
Stock firmwares for the WeMo Smart Switch (F7C027) are available under the download section on the
modem’s
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.
