How to factory reset Buffalo WZR-600DHP router – Default Login & Password

The Buffalo WZR-600DHP router has 300mbps WiFi, 4 Gigabit ETH-ports and 0 USB-ports. It also supports custom firmwares like: dd-wrt, OpenWrt
How to factory reset Buffalo WZR-600DHP - Default Login & Password

Buffalo WZR-600DHP default Password , Login & Gateway settings :

Default Gateway IP: 192.168.11.1
Default username: admin
Default password: password
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.11.1

How to factory reset (hard reset) Buffalo WZR-600DHP :

You can factory reset your Buffalo WZR-600DHP in the following way(s)
1. When the router is on, press the button reset and hold for 30 seconds.
2. While holding down the button reset, turn off the power of the router and hold down the button reset for 30 seconds
3. While holding down the button reset, turn on the power to the unit again and hold for another 30 seconds

Buffalo WZR-600DHP router specifications :

System specs
CPU: 680 MHz
RAM: 128 MiB
Flash: 32 MiB
Custom firmwares: dd-wrt, OpenWrt
Connectivity
WiFi: 300mbps (abgn)
WiFi bands
2.4GHz & 5GHz
WiFi throughput: n/a
WAN
1 x Gigabit port
ETH
4 x Gigabit ports
USB-ports: 0
WZR-600DHP Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
secure
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
flashing
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
increase
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Buffalo WZR-600DHP
Flashing dd-wrt on the Buffalo WZR-600DHP
Since the WZR-600DHP has 32 MiB of flash memory, you should be able to
run
dd-wrt with full functionality without having to worry too much about which firmware
to
use.
We haven’t find any specific instructions for flashin dd-wrt onto the Buffalo
WZR-600DHP, but you can read the
Installation guide over at dd-wrt to get a clue on how to proceed (As this model is listed as
supported).
Note: Always make sure to read the wiki and howtos of dd-wrt before doing any
flashing.
Flashing OpenWrt on the Buffalo WZR-600DHP
The Buffalo WZR-600DHP is supported by OpenWrt according to their Table of
Hardware. So
flashing OpenWrt onto it should be quite straigthforward.
We couldn’t find any specific instructions for flashin OpenWrt on the Buffalo
WZR-600DHP, but since it’s listed in their Table of Hardware as supported, you can
head
over to the
OpenWrt install instructions and read on there.
Note: Flashing custom firmwares is always on you’re on own risk. Make sure to
read OpenWrt’s wikis to understand the risks and how to proceed if something goes
wrong.