How to factory reset Cisco Valet Plus M20 router – Default Login & Password

The Cisco Valet Plus M20 router has 300mbps WiFi, 4 Gigabit ETH-ports and 0 USB-ports. It also supports custom firmwares like: dd-wrt, OpenWrt

Cisco Valet Plus M20 default Password , Login & Gateway settings :

Default Gateway IP: 192.168.1.1
Default username: admin
Default password: admin
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.1.1

How to factory reset (hard reset) Cisco Valet Plus M20 :

You can factory reset your Cisco Valet Plus M20 in the following way(s)
1. When the router is on, press the button reset and hold for 30 seconds.
2. While holding down the button reset, turn off the power of the router and hold down the button reset for 30 seconds
3. While holding down the button reset, turn on the power to the unit again and hold for another 30 seconds

Cisco Valet Plus M20 router specifications :

System specs
CPU: n/a
RAM: 32 MiB
Flash: 4 MiB
Custom firmwares: dd-wrt, OpenWrt
Connectivity
WiFi: 300mbps (bgn)
WiFi bands
2.4GHz
WiFi throughput: n/a
WAN
1 x Gigabit port
ETH
4 x Gigabit ports
USB-ports: 0
Cisco M20 review (quick overview)
Here is the quick comparison of how the Cisco M20 compares to
other routers on our site
Average
26/100
Editor
72/100
WiFi
6/100
Hardware
2/100
Current price
$18.98
For a full list of routers and how they compare to the Valet Plus M20, check the
Router Buying Guide which will help you buy the most
price-competitive router.
Valet Plus M20 Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
secure
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
flashing
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
increase
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Cisco Valet Plus M20
Flashing dd-wrt on the Cisco Valet Plus M20
Since the Valet Plus M20 has 4 MiB of flash memory, you should choose a
stripped down version of dd-wrt that fits on the smaller flash.
Instructions on how to flash dd-wrt onto your Cisco Valet Plus M20 can be found
on
the
dd-wrt wiki
Note: Always make sure to read the wiki and howtos of dd-wrt before doing any
flashing.
Flashing OpenWrt on the Cisco Valet Plus M20
The Cisco Valet Plus M20 is supported by OpenWrt according to their Table of
Hardware. So
flashing OpenWrt onto it should be quite straigthforward.
To get started with the flashing, head over to the
OpenWrt instructions for Valet Plus M20 and they’ll take it from there.
Note: Flashing custom firmwares is always on you’re on own risk. Make sure to
read OpenWrt’s wikis to understand the risks and how to proceed if something goes
wrong.
Cisco stock firmware for the Valet Plus M20
Stock firmwares for the Valet Plus M20 are available under the download section on the
modem’s
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.