How to factory reset D-Link DCH-S150 rev A1 router – Default Login & Password

The D-Link DCH-S150 rev A1 router has 300mbps WiFi, N/A ETH-ports and 0 USB-ports.
It is also known as the D-Link Wi-Fi Smart Motion Sensor.
How to factory reset D-Link DCH-S150 rev A1 - Default Login & Password

D-Link DCH-S150 rev A1 default Password , Login & Gateway settings :

If you have performed a reset of your DCH-S150 rev A1 device or not changed the defaults, you
should
be able to access it with the following settings
Default subnet mask: 255.255.255.0

How to factory reset (hard reset) D-Link DCH-S150 rev A1 :

You can factory reset your D-Link DCH-S150 rev A1 in the following way(s)
With the reset button
Locate the reset button on the back off the router
While the unit is powered on, press the reset button with a sharp object (e.g. paperclip)
Hold the button pressed for 10 seconds, then release.
The unit will reboot by itself and once the WLAN light stops blinking the factory reset is done.
You can now setup your router again through the user interface

D-Link DCH-S150 rev A1 router specifications :

System specs
CPU: n/a
RAM: 32 MiB
Flash: 8 MiB
Custom firmwares: None
Connectivity
WiFi: 300mbps (bgn)
WiFi bands
2.4GHz
WiFi throughput: n/a
WAN
None
ETH
None
USB-ports: 0
DCH-S150 rev A1 Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
secure
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
flashing
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
increase
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the D-Link DCH-S150 rev A1
D-Link stock firmware for the DCH-S150 rev A1
Stock firmwares for the DCH-S150 rev A1 are available under the download section on the
modem’s
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.