The D-Link DSA-3200 router has 54mbps WiFi, 4 100mbps ETH-ports and 0 USB-ports.
D-Link DSA-3200 default Password , Login & Gateway settings :
Default Gateway IP: 192.168.0.40
D-Link login instructions
Default username: admin
D-Link router default password list
Default password: admin
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.0.40
How to factory reset (hard reset) D-Link DSA-3200 :
You can factory reset your D-Link DSA-3200 in the following way(s)
With the reset button
Locate the reset button on the back off the router
While the unit is powered on, press the reset button with a sharp object (e.g. paperclip)
Hold the button pressed for 10 seconds, then release.
The unit will reboot by itself and once the WLAN light stops blinking the factory reset is done.
You can now setup your router again through the user interface
How to login to the D-Link DSA-3200 :
Make sure you are connected to the router’s network, either by Wi-Fi or ethernet cable.
Open your browser and visit
You should be prompted with a login dialogue.
Enter the username: admin
and the password admin
You will now be logged in. If you haven’t yet changed the defaul password, we recommend that you change it first
thing you do after logging in.
D-Link DSA-3200 router specifications :
CPU: 266 MHz
RAM: 32 MiB
Flash: 16 MiB
Custom firmwares: None
WiFi: 54mbps (bg)
WiFi throughput: n/a
1 x 100mbps port
4 x 100mbps ports
Staying up to date with the latest firmware is a good idea to keep your router even more
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the D-Link DSA-3200
D-Link stock firmware for the DSA-3200
Stock firmwares for the DSA-3200 are available under the download section on the
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.