How to factory reset D-Link DSR-500N router – Default Login & Password

The D-Link DSR-500N router has 300mbps WiFi, 4 Gigabit ETH-ports and 0 USB-ports.
It is also known as the D-Link Wireless Services Router.
How to factory reset D-Link DSR-500N - Default Login & Password

D-Link DSR-500N default Password , Login & Gateway settings :

If you have performed a reset of your DSR-500N device or not changed the defaults, you
should
be able to access it with the following settings
Default subnet mask: 255.255.255.0

How to factory reset (hard reset) D-Link DSR-500N :

You can factory reset your D-Link DSR-500N in the following way(s)
With the reset button
Locate the reset button on the back off the router
While the unit is powered on, press the reset button with a sharp object (e.g. paperclip)
Hold the button pressed for 10 seconds, then release.
The unit will reboot by itself and once the WLAN light stops blinking the factory reset is done.
You can now setup your router again through the user interface

D-Link DSR-500N router specifications :

System specs
CPU: 300 MHz
RAM: 128 MiB
Flash: 32 MiB
Custom firmwares: None
Connectivity
WiFi: 300mbps (bgn)
WiFi bands
2.4GHz & 5GHz
WiFi throughput: n/a
WAN
2 x Gigabit ports
ETH
4 x Gigabit ports
USB-ports: 0
DSR-500N Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
secure
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
flashing
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
increase
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the D-Link DSR-500N
D-Link stock firmware for the DSR-500N
Stock firmwares for the DSR-500N are available under the download section on the
modem’s
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.

D-Link