How to factory reset D-Link DWL-2000AP+ rev A1 router – Default Login & Password

The D-Link DWL-2000AP+ rev A1 router has 54mbps WiFi, 1 100mbps ETH-ports and 0 USB-ports.
It is also known as the D-Link AirPlus Xtreme G+ 2.4GHz (802.11g) Wireless Access Point.
How to factory reset D-Link DWL-2000AP+ rev A1 - Default Login & Password

D-Link DWL-2000AP+ rev A1 default Password , Login & Gateway settings :

If you have performed a reset of your DWL-2000AP+ rev A1 device or not changed the defaults, you
be able to access it with the following settings
Default subnet mask:

How to factory reset (hard reset) D-Link DWL-2000AP+ rev A1 :

You can factory reset your D-Link DWL-2000AP+ rev A1 in the following way(s)
With the reset button
Locate the reset button on the back off the router
While the unit is powered on, press the reset button with a sharp object (e.g. paperclip)
Hold the button pressed for 10 seconds, then release.
The unit will reboot by itself and once the WLAN light stops blinking the factory reset is done.
You can now setup your router again through the user interface

D-Link DWL-2000AP+ rev A1 router specifications :

System specs
CPU: n/a
RAM: 8 MiB
Flash: 1 MiB
Custom firmwares: None
WiFi: 54mbps (bg)
WiFi bands
WiFi throughput: n/a
1 x 100mbps port
USB-ports: 0
DWL-2000AP+ rev A1 Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the D-Link DWL-2000AP+ rev A1
D-Link stock firmware for the DWL-2000AP+ rev A1
Stock firmwares for the DWL-2000AP+ rev A1 are available under the download section on the
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.