How to factory reset D-Link DWL-2100AP rev A4 router – Default Login & Password

The D-Link DWL-2100AP rev A4 router has 54mbps WiFi, 1 100mbps ETH-ports and 0 USB-ports.
How to factory reset D-Link DWL-2100AP rev A4 - Default Login & Password

D-Link DWL-2100AP rev A4 default Password , Login & Gateway settings :

Default Gateway IP: 192.168.0.50
D-Link login instructions
Default username: admin
D-Link router default password list
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.0.50

How to factory reset (hard reset) D-Link DWL-2100AP rev A4 :

You can factory reset your D-Link DWL-2100AP rev A4 in the following way(s)
With the reset button
Locate the reset button on the back off the router
While the unit is powered on, press the reset button with a sharp object (e.g. paperclip)
Hold the button pressed for 10 seconds, then release.
The unit will reboot by itself and once the WLAN light stops blinking the factory reset is done.
You can now setup your router again through the user interface

How to login to the D-Link DWL-2100AP rev A4 :

Make sure you are connected to the router’s network, either by Wi-Fi or ethernet cable.
Open your browser and visit
http://192.168.0.50
You should be prompted with a login dialogue.
Enter the username: admin
and if it requires a password, leave it empty or try with admin / password
You will now be logged in. If you haven’t yet changed the defaul password, we recommend that you change it first
thing you do after logging in.

D-Link DWL-2100AP rev A4 router specifications :

System specs
CPU: 180 MHz
RAM: 16 MiB
Flash: 4 MiB
Custom firmwares: OpenWrt
Connectivity
WiFi: 54mbps (bg)
WiFi bands
2.4GHz
WiFi throughput: n/a
WAN
None
ETH
1 x 100mbps port
USB-ports: 0
DWL-2100AP rev A4 Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
secure
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
flashing
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
increase
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the D-Link DWL-2100AP rev A4
Flashing OpenWrt on the D-Link DWL-2100AP rev A4
The D-Link DWL-2100AP rev A4 is supported by OpenWrt according to their Table of
Hardware. So
flashing OpenWrt onto it should be quite straigthforward.
We couldn’t find any specific instructions for flashin OpenWrt on the D-Link
DWL-2100AP rev A4, but since it’s listed in their Table of Hardware as supported, you can
head
over to the
OpenWrt install instructions and read on there.
Note: Flashing custom firmwares is always on you’re on own risk. Make sure to
read OpenWrt’s wikis to understand the risks and how to proceed if something goes
wrong.
D-Link stock firmware for the DWL-2100AP rev A4
Stock firmwares for the DWL-2100AP rev A4 are available under the download section on the
modem’s
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.