The D-Link TM-G5240 router has 54mbps WiFi, 4 100mbps ETH-ports and 0 USB-ports.
D-Link TM-G5240 default Password , Login & Gateway settings :
Default Gateway IP: 192.168.0.1
D-Link login instructions
Default password: admin
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.0.1
How to factory reset (hard reset) D-Link TM-G5240 :
You can factory reset your D-Link TM-G5240 in the following way(s)
With the reset button
Locate the reset button on the back off the router
While the unit is powered on, press the reset button with a sharp object (e.g. paperclip)
Hold the button pressed for 10 seconds, then release.
The unit will reboot by itself and once the WLAN light stops blinking the factory reset is done.
You can now setup your router again through the user interface
D-Link TM-G5240 router specifications :
RAM: 16 MiB
Flash: 4 MiB
Custom firmwares: None
WiFi: 54mbps (bg)
WiFi throughput: n/a
1 x 100mbps port
4 x 100mbps ports
Staying up to date with the latest firmware is a good idea to keep your router even more
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the D-Link TM-G5240
D-Link stock firmware for the TM-G5240
Stock firmwares for the TM-G5240 are available under the download section on the
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.