The Linksys WRT600N v1.1 router has 300mbps WiFi, 4 Gigabit ETH-ports and 0 USB-ports.
It is also known as the Linksys Dual-Band Wireless-N Gigabit Router with Storage Link. It also supports custom firmwares like: dd-wrt, OpenWrt
Linksys WRT600N v1.1 default Password , Login & Gateway settings :
Default Gateway IP: 192.168.1.1
Linksys login instructions
Default password: admin
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.1.1
How to factory reset (hard reset) Linksys WRT600N v1.1 :
You can factory reset your Linksys WRT600N v1.1 in the following way(s)
Through the web interface
Open your browser and navigate to the router interface (see default settings below)
Under the Administration tab you will find a sub-tab called Factory defaults
On the Factory defaults page click the button labeled Restore Factory Defaults
With the reset button
Have your unit powered on
Press and hold the reset button for at least 10 seconds until the power light starts blinking, then release.
When the power light goes solid, unplug the power to the router for 10 seconds
Plug the power back in and start the router
When the power light goes solid again the router is ready to use.
Linksys WRT600N v1.1 router specifications :
CPU: 300 MHz
RAM: 32 MiB
Flash: 8 MiB
Custom firmwares: dd-wrt, OpenWrt
WiFi: 300mbps (abgn)
2.4GHz & 5GHz
WiFi throughput: n/a
1 x Gigabit port
4 x Gigabit ports
WRT600N v1.1 Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Linksys WRT600N v1.1
Flashing dd-wrt on the Linksys WRT600N v1.1
Instructions on how to flash dd-wrt onto your Linksys WRT600N v1.1 can be found
Note: Always make sure to read the wiki and howtos of dd-wrt before doing any
Flashing OpenWrt on the Linksys WRT600N v1.1
The Linksys WRT600N v1.1 is supported by OpenWrt according to their Table of
flashing OpenWrt onto it should be quite straigthforward.
To get started with the flashing, head over to the
OpenWrt instructions for WRT600N v1.1 and they’ll take it from there.
Note: Flashing custom firmwares is always on you’re on own risk. Make sure to
read OpenWrt’s wikis to understand the risks and how to proceed if something goes
Linksys stock firmware for the WRT600N v1.1
Stock firmwares for the WRT600N v1.1 are available under the download section on the
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.