The MikroTik RouterBOARD hAP lite (RB941-2nD-TC) router has 300mbps WiFi, 3 100mbps ETH-ports and 0 USB-ports.
It is also known as the MikroTik MikroTik hAP lite – Home Access Point. It also supports custom firmwares like: LEDE Project
MikroTik RouterBOARD hAP lite (RB941-2nD-TC) default Password , Login & Gateway settings :
Default Gateway IP: 192.168.88.1
Default username: admin
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.88.1
How to factory reset (hard reset) MikroTik RouterBOARD hAP lite (RB941-2nD-TC) :
You can factory reset your MikroTik RouterBOARD hAP lite (RB941-2nD-TC) in the following way(s)
1. When the router is on, press the button reset and hold for 30 seconds.
2. While holding down the button reset, turn off the power of the router and hold down the button reset for 30 seconds
3. While holding down the button reset, turn on the power to the unit again and hold for another 30 seconds
MikroTik RouterBOARD hAP lite (RB941-2nD-TC) router specifications :
CPU: 650 MHz
RAM: 32 MiB
Flash: 16 MiB
Custom firmwares: LEDE Project
WiFi: 300mbps (bgn)
WiFi throughput: n/a
1 x 100mbps port
3 x 100mbps ports
MikroTik RouterBOARD hAP review (quick overview)
Here is the quick comparison of how the MikroTik RouterBOARD hAP compares to
other routers on our site
For a full list of routers and how they compare to the RouterBOARD hAP lite (RB941-2nD-TC), check the
Router Buying Guide which will help you buy the most
RouterBOARD hAP lite (RB941-2nD-TC) Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the MikroTik RouterBOARD hAP lite (RB941-2nD-TC)
Flashing LEDE Project on the RouterBOARD hAP lite (RB941-2nD-TC)
The MikroTik RouterBOARD hAP lite (RB941-2nD-TC) is also supported by the LEDE Project.
To install LEDE aquire the correct firmware from their
Firmware downloads page and
then follow the instructions on their
Quick Start Guide
Note: Make sure to read the LEDE wikis carefully before flashing.