The Netgear DG834Gv3 router has 54mbps WiFi, 4 100mbps ETH-ports and 0 USB-ports.
Netgear DG834Gv3 default Password , Login & Gateway settings :
Default Gateway IP: 192.168.0.1
Netgear login instructions
Default username: admin
Netgear router default password list
Default password: password
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.0.1
How to factory reset (hard reset) Netgear DG834Gv3 :
You can factory reset your Netgear DG834Gv3 in the following way(s)
With the reset button
Have the router powered on (if just booted wait around one minute for it to load)
With a sharp pen or paper clip, press down the Restore Factory Settings button and hold it for about 7 seconds
When the power light starts to blink you can release the reset button and wait for the router to start up
The power light will be solid (not blinking) once the router is started.
How to login to the Netgear DG834Gv3 :
Make sure you are connected to the router’s network, either by Wi-Fi or ethernet cable.
Open your browser and visit
You should be prompted with a login dialogue.
Enter the username: admin
and the password password
You will now be logged in. If you haven’t yet changed the defaul password, we recommend that you change it first
thing you do after logging in.
Netgear DG834Gv3 router specifications :
RAM: 16 MiB
Flash: 4 MiB
Custom firmwares: OpenWrt
WiFi: 54mbps (bg)
WiFi throughput: n/a
4 x 100mbps ports
Staying up to date with the latest firmware is a good idea to keep your router even more
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Netgear DG834Gv3
Flashing OpenWrt on the Netgear DG834Gv3
The Netgear DG834Gv3 is supported by OpenWrt according to their Table of
flashing OpenWrt onto it should be quite straigthforward.
We couldn’t find any specific instructions for flashin OpenWrt on the Netgear
DG834Gv3, but since it’s listed in their Table of Hardware as supported, you can
over to the
OpenWrt install instructions and read on there.
Note: Flashing custom firmwares is always on you’re on own risk. Make sure to
read OpenWrt’s wikis to understand the risks and how to proceed if something goes
Netgear stock firmware for the DG834Gv3
Stock firmwares for the DG834Gv3 are available under the download section on the
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.