The Netgear EX6100v2 router has Gigabit WiFi, 1 Gigabit ETH-ports and 0 USB-ports. It has a total combined WiFi throughput of 750 Mpbs.
It is also known as the Netgear AC750 WiFi Range Extender.
Netgear EX6100v2 default Password , Login & Gateway settings :
If you have performed a reset of your EX6100v2 device or not changed the defaults, you
be able to access it with the following settings
Default subnet mask: 255.255.255.0
How to factory reset (hard reset) Netgear EX6100v2 :
You can factory reset your Netgear EX6100v2 in the following way(s)
With the reset button
Have the router powered on (if just booted wait around one minute for it to load)
With a sharp pen or paper clip, press down the Restore Factory Settings button and hold it for about 7 seconds
When the power light starts to blink you can release the reset button and wait for the router to start up
The power light will be solid (not blinking) once the router is started.
Netgear EX6100v2 router specifications :
CPU: 717 MHz
RAM: 256 MiB
Flash: 16 MiB
Custom firmwares: None
WiFi: Gigabit (abgn+ac)
2.4GHz & 5GHz
WiFi throughput: 750 Mpbs
1 x Gigabit port
Staying up to date with the latest firmware is a good idea to keep your router even more
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Netgear EX6100v2
Netgear stock firmware for the EX6100v2
Stock firmwares for the EX6100v2 are available under the download section on the
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.