How to factory reset Netgear EX6250 router – Default Login & Password

The Netgear EX6250 router has Gigabit WiFi, 1 Gigabit ETH-ports and 0 USB-ports. It has a total combined WiFi throughput of 1750 Mpbs.
How to factory reset Netgear EX6250 - Default Login & Password

Netgear EX6250 default Password , Login & Gateway settings :

If you have performed a reset of your EX6250 device or not changed the defaults, you
should
be able to access it with the following settings
Default subnet mask: 255.255.255.0

How to factory reset (hard reset) Netgear EX6250 :

You can factory reset your Netgear EX6250 in the following way(s)
With the reset button
Have the router powered on (if just booted wait around one minute for it to load)
With a sharp pen or paper clip, press down the Restore Factory Settings button and hold it for about 7 seconds
When the power light starts to blink you can release the reset button and wait for the router to start up
The power light will be solid (not blinking) once the router is started.

Netgear EX6250 router specifications :

System specs
CPU: n/a
RAM: 128 MiB
Flash: 16 MiB
Custom firmwares: None
Connectivity
WiFi: Gigabit (abgn+ac)
WiFi bands
2.4GHz & 5GHz
WiFi throughput: 1750 Mpbs
WAN
None
ETH
1 x Gigabit port
USB-ports: 0
EX6250 Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
secure
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
flashing
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
increase
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Netgear EX6250
Netgear stock firmware for the EX6250
Stock firmwares for the EX6250 are available under the download section on the
modem’s
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.