How to factory reset Netgear JNR1010v2 router – Default Login & Password

The Netgear JNR1010v2 router has 300mbps WiFi, 4 100mbps ETH-ports and 0 USB-ports.
How to factory reset Netgear JNR1010v2 - Default Login & Password

Netgear JNR1010v2 default Password , Login & Gateway settings :

If you have performed a reset of your JNR1010v2 device or not changed the defaults, you
should
be able to access it with the following settings
Default username: admin
Netgear router default password list
Default password: password
Default subnet mask: 255.255.255.0

How to factory reset (hard reset) Netgear JNR1010v2 :

You can factory reset your Netgear JNR1010v2 in the following way(s)
With the reset button
Have the router powered on (if just booted wait around one minute for it to load)
With a sharp pen or paper clip, press down the Restore Factory Settings button and hold it for about 7 seconds
When the power light starts to blink you can release the reset button and wait for the router to start up
The power light will be solid (not blinking) once the router is started.

Netgear JNR1010v2 router specifications :

System specs
CPU: 580 MHz
RAM: 32 MiB
Flash: 4 MiB
Custom firmwares: None
Connectivity
WiFi: 300mbps (bgn)
WiFi bands
2.4GHz
WiFi throughput: n/a
WAN
1 x 100mbps port
ETH
4 x 100mbps ports
USB-ports: 0
JNR1010v2 Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
secure
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
flashing
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
increase
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Netgear JNR1010v2
Netgear stock firmware for the JNR1010v2
Stock firmwares for the JNR1010v2 are available under the download section on the
modem’s
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.