How to factory reset Netgear ME102 rev B router – Default Login & Password

The Netgear ME102 rev B router has 11mbps WiFi, 1 100mbps ETH-ports and 0 USB-ports.
How to factory reset Netgear ME102 rev B - Default Login & Password

Netgear ME102 rev B default Password , Login & Gateway settings :

If you have performed a reset of your ME102 rev B device or not changed the defaults, you
should
be able to access it with the following settings
Default Network name (SSID): Wireless
Default subnet mask: 255.255.255.0

How to factory reset (hard reset) Netgear ME102 rev B :

You can factory reset your Netgear ME102 rev B in the following way(s)
With the reset button
Have the router powered on (if just booted wait around one minute for it to load)
With a sharp pen or paper clip, press down the Restore Factory Settings button and hold it for about 7 seconds
When the power light starts to blink you can release the reset button and wait for the router to start up
The power light will be solid (not blinking) once the router is started.

Netgear ME102 rev B router specifications :

System specs
CPU: n/a
RAM: n/a
Flash: 0.5 MiB
Custom firmwares: None
Connectivity
WiFi: 11mbps (b)
WiFi bands
2.4GHz
WiFi throughput: n/a
WAN
None
ETH
1 x 100mbps port
USB-ports: 0
ME102 rev B Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
secure
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
flashing
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
increase
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Netgear ME102 rev B
Netgear stock firmware for the ME102 rev B
Stock firmwares for the ME102 rev B are available under the download section on the
modem’s
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.

NetGear