The Netgear NTV200 router has 300mbps WiFi, 1 100mbps ETH-ports and 0 USB-ports.
Netgear NTV200 default Password , Login & Gateway settings :
If you have performed a reset of your NTV200 device or not changed the defaults, you
be able to access it with the following settings
Default subnet mask: 255.255.255.0
How to factory reset (hard reset) Netgear NTV200 :
You can factory reset your Netgear NTV200 in the following way(s)
With the reset button
Have the router powered on (if just booted wait around one minute for it to load)
With a sharp pen or paper clip, press down the Restore Factory Settings button and hold it for about 7 seconds
When the power light starts to blink you can release the reset button and wait for the router to start up
The power light will be solid (not blinking) once the router is started.
Netgear NTV200 router specifications :
RAM: 256 MiB
Custom firmwares: None
WiFi: 300mbps (bgn)
WiFi throughput: n/a
1 x 100mbps port
Staying up to date with the latest firmware is a good idea to keep your router even more
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Netgear NTV200
Netgear stock firmware for the NTV200
Stock firmwares for the NTV200 are available under the download section on the
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.