The Netgear Orbi Pro Router (SRR60) router has Gigabit WiFi, 3 Gigabit ETH-ports and 0 USB-ports. It has a total combined WiFi throughput of 3000 Mpbs.
Netgear Orbi Pro Router (SRR60) default Password , Login & Gateway settings :
If you have performed a reset of your Orbi Pro Router (SRR60) device or not changed the defaults, you
be able to access it with the following settings
Default subnet mask: 255.255.255.0
How to factory reset (hard reset) Netgear Orbi Pro Router (SRR60) :
You can factory reset your Netgear Orbi Pro Router (SRR60) in the following way(s)
With the reset button
Have the router powered on (if just booted wait around one minute for it to load)
With a sharp pen or paper clip, press down the Restore Factory Settings button and hold it for about 7 seconds
When the power light starts to blink you can release the reset button and wait for the router to start up
The power light will be solid (not blinking) once the router is started.
Netgear Orbi Pro Router (SRR60) router specifications :
CPU: 717 MHz
RAM: 512 MiB
Flash: 4096 MiB
Custom firmwares: None
WiFi: Gigabit (abgn+ac)
WiFi throughput: 3000 Mpbs
1 x Gigabit port
3 x Gigabit ports
Orbi Pro Router (SRR60) Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Netgear Orbi Pro Router (SRR60)
Netgear stock firmware for the Orbi Pro Router (SRR60)
Stock firmwares for the Orbi Pro Router (SRR60) are available under the download section on the
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.