The Netgear PTV3000 router has 300mbps WiFi, N/A ETH-ports and 0 USB-ports.
Netgear PTV3000 default Password , Login & Gateway settings :
If you have performed a reset of your PTV3000 device or not changed the defaults, you
be able to access it with the following settings
Default subnet mask: 255.255.255.0
How to factory reset (hard reset) Netgear PTV3000 :
You can factory reset your Netgear PTV3000 in the following way(s)
With the reset button
Have the router powered on (if just booted wait around one minute for it to load)
With a sharp pen or paper clip, press down the Restore Factory Settings button and hold it for about 7 seconds
When the power light starts to blink you can release the reset button and wait for the router to start up
The power light will be solid (not blinking) once the router is started.
Netgear PTV3000 router specifications :
RAM: 256 MiB
Flash: 128 MiB
Custom firmwares: None
WiFi: 300mbps (abgn)
2.4GHz & 5GHz
WiFi throughput: n/a
Staying up to date with the latest firmware is a good idea to keep your router even more
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Netgear PTV3000
Netgear stock firmware for the PTV3000
Stock firmwares for the PTV3000 are available under the download section on the
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.