How to factory reset Netgear RAX20 router – Default Login & Password

The Netgear RAX20 router has Gigabit WiFi, 4 N/A ETH-ports and 0 USB-ports.
It is also known as the Netgear AX1800 Wi-Fi Router.

Netgear RAX20 default Password , Login & Gateway settings :

If you have performed a reset of your RAX20 device or not changed the defaults, you
should
be able to access it with the following settings
Default username: admin
Netgear router default password list
Default password: password
Default subnet mask: 255.255.255.0

How to factory reset (hard reset) Netgear RAX20 :

You can factory reset your Netgear RAX20 in the following way(s)
With the reset button
Have the router powered on (if just booted wait around one minute for it to load)
With a sharp pen or paper clip, press down the Restore Factory Settings button and hold it for about 7 seconds
When the power light starts to blink you can release the reset button and wait for the router to start up
The power light will be solid (not blinking) once the router is started.

Netgear RAX20 router specifications :

System specs
CPU: n/a
RAM: n/a
Flash: n/a
Custom firmwares: None
Connectivity
WiFi: Gigabit (abgn+ac+ax)
WiFi bands
2.4GHz & 5GHz
WiFi throughput: n/a
WAN
1 x N/A port
ETH
4 x N/A ports
USB-ports: 0