The Amped Wireless RTA1300M router has Gigabit WiFi, 4 Gigabit ETH-ports and 0 USB-ports. It has a total combined WiFi throughput of 1300 Mpbs.
It is also known as the Amped Wireless ARTEMIS High Power AC1300 Wi-Fi Router with MU-MIMO. It also supports custom firmwares like: LEDE Project
RTA1300M default Password , Login & Gateway settings :
Default Gateway IP: 192.168.3.1
Amped Wireless login instructions
Default username: admin
Amped Wireless router default password list
Default password: admin
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.3.1
How to factory reset (hard reset) RTA1300M :
You can factory reset your Amped Wireless RTA1300M in the following way(s)
1. When the router is on, press the button reset and hold for 30 seconds.
2. While holding down the button reset, turn off the power of the router and hold down the button reset for 30 seconds
3. While holding down the button reset, turn on the power to the unit again and hold for another 30 seconds
RTA1300M router specifications :
System specs
CPU: 638 MHz
RAM: 128 MiB
Flash: 16 MiB
Custom firmwares: LEDE Project
Connectivity
WiFi: Gigabit (abgn+ac)
WiFi bands
2.4GHz & 5GHz
WiFi throughput: 1300 Mpbs
WAN
1 x Gigabit port
ETH
4 x Gigabit ports
USB-ports: 0
RTA1300M Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
secure
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
flashing
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
increase
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Amped Wireless RTA1300M
Flashing LEDE Project on the RTA1300M
The Amped Wireless RTA1300M is also supported by the LEDE Project.
To install LEDE aquire the correct firmware from their
Firmware downloads page and
then follow the instructions on their
Quick Start Guide
Note: Make sure to read the LEDE wikis carefully before flashing.
