How to factory reset WeVO Hi1200AC router – Default Login & Password

The WeVO Hi1200AC router has Gigabit WiFi, 4 Gigabit ETH-ports and 0 USB-ports. It also supports custom firmwares like: LEDE Project

WeVO Hi1200AC default Password , Login & Gateway settings :

Default Gateway IP: 192.168.10.1
Default username: admin
Default password: DZY-W2914NSV2
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.10.1

How to factory reset (hard reset) WeVO Hi1200AC :

You can factory reset your WeVO Hi1200AC in the following way(s)
1. When the router is on, press the button reset and hold for 30 seconds.
2. While holding down the button reset, turn off the power of the router and hold down the button reset for 30 seconds
3. While holding down the button reset, turn on the power to the unit again and hold for another 30 seconds

WeVO Hi1200AC router specifications :

System specs
CPU: 880 MHz
RAM: 128 MiB
Flash: 16 MiB
Custom firmwares: LEDE Project
Connectivity
WiFi: Gigabit (abgn+ac)
WiFi bands
n/a
WiFi throughput: n/a
WAN
1 x Gigabit port
ETH
4 x Gigabit ports
USB-ports: 0
Hi1200AC Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
secure
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
flashing
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
increase
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the WeVO Hi1200AC
Flashing LEDE Project on the Hi1200AC
The WeVO Hi1200AC is also supported by the LEDE Project.
To install LEDE aquire the correct firmware from their
Firmware downloads page and
then follow the instructions on their
Quick Start Guide
Note: Make sure to read the LEDE wikis carefully before flashing.