The WeVO W2914NS v2 router has Gigabit WiFi, 4 N/A ETH-ports and 0 USB-ports.
It is also known as the WeVO 11AC Giga NVR Router. It also supports custom firmwares like: LEDE Project
WeVO W2914NS v2 default Password , Login & Gateway settings :
Default Gateway IP: 192.168.10.1
Default username: admin
Default password: DZY-W2914NSV2
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.10.1
How to factory reset (hard reset) WeVO W2914NS v2 :
You can factory reset your WeVO W2914NS v2 in the following way(s)
1. When the router is on, press the button reset and hold for 30 seconds.
2. While holding down the button reset, turn off the power of the router and hold down the button reset for 30 seconds
3. While holding down the button reset, turn on the power to the unit again and hold for another 30 seconds
WeVO W2914NS v2 router specifications :
System specs
CPU: 880 MHz
RAM: 128 MiB
Flash: 16 MiB
Custom firmwares: LEDE Project
Connectivity
WiFi: Gigabit (abgn+ac)
WiFi bands
n/a
WiFi throughput: n/a
WAN
1 x N/A port
ETH
4 x N/A ports
USB-ports: 0
W2914NS v2 Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
secure
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
flashing
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
increase
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the WeVO W2914NS v2
Flashing LEDE Project on the W2914NS v2
The WeVO W2914NS v2 is also supported by the LEDE Project.
To install LEDE aquire the correct firmware from their
Firmware downloads page and
then follow the instructions on their
Quick Start Guide
Note: Make sure to read the LEDE wikis carefully before flashing.
