The Linksys Velop (WHW03 V2) router has Gigabit WiFi, ETH-ports and 0 USB-ports.
The Velop (WHW03 V2) is featured in our
Best Low-end routers: buying guide
Linksys Velop (WHW03 V2) default Password , Login & Gateway settings :
If you have performed a reset of your Velop (WHW03 V2) device or not changed the defaults, you
should
be able to access it with the following settings
Default subnet mask: 255.255.255.0
How to factory reset (hard reset) Linksys Velop (WHW03 V2) :
You can factory reset your Linksys Velop (WHW03 V2) in the following way(s)
Through the web interface
Open your browser and navigate to the router interface (see default settings below)
Under the Administration tab you will find a sub-tab called Factory defaults
On the Factory defaults page click the button labeled Restore Factory Defaults
With the reset button
Have your unit powered on
Press and hold the reset button for at least 10 seconds until the power light starts blinking, then release.
When the power light goes solid, unplug the power to the router for 10 seconds
Plug the power back in and start the router
When the power light goes solid again the router is ready to use.
Linksys Velop (WHW03 V2) router specifications :
System specs
CPU: n/a
RAM: 512 MiB
Flash: 512 MiB
Custom firmwares: None
Connectivity
WiFi: Gigabit (abgn+ac)
WiFi bands
2.4GHz & 5GHz
WiFi throughput: n/a
WAN
None
ETH
None
USB-ports: 0
Linksys Velop review (quick overview)
Here is the quick comparison of how the Linksys Velop compares to
other routers on our site
Average
50/100
Editor
82/100
WiFi
20/100
Hardware
50/100
Current price
$46.99
For a full list of routers and how they compare to the Velop (WHW03 V2), check the
Router Buying Guide which will help you buy the most
price-competitive router.
