The Linksys WRT54GP2A-AT router has 54mbps WiFi, 4 100mbps ETH-ports and 0 USB-ports.
It is also known as the Linksys Wireless-G Broadband Router with 2 Phone Ports.
Linksys WRT54GP2A-AT default Password , Login & Gateway settings :
Default Gateway IP: 192.168.15.1
Linksys login instructions
Default password: admin
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.15.1
How to factory reset (hard reset) Linksys WRT54GP2A-AT :
You can factory reset your Linksys WRT54GP2A-AT in the following way(s)
Through the web interface
Open your browser and navigate to the router interface (see default settings below)
Under the Administration tab you will find a sub-tab called Factory defaults
On the Factory defaults page click the button labeled Restore Factory Defaults
With the reset button
Have your unit powered on
Press and hold the reset button for at least 10 seconds until the power light starts blinking, then release.
When the power light goes solid, unplug the power to the router for 10 seconds
Plug the power back in and start the router
When the power light goes solid again the router is ready to use.
Linksys WRT54GP2A-AT router specifications :
CPU: 400 MHz
RAM: 32 MiB
Flash: 8 MiB
Custom firmwares: None
WiFi: 54mbps (bg)
WiFi throughput: n/a
1 x 100mbps port
4 x 100mbps ports
Staying up to date with the latest firmware is a good idea to keep your router even more
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Linksys WRT54GP2A-AT
Linksys stock firmware for the WRT54GP2A-AT
Stock firmwares for the WRT54GP2A-AT are available under the download section on the
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.