How to factory reset MQmaker WiTi Board router – Default Login & Password

The MQmaker WiTi Board router has Gigabit WiFi, 4 Gigabit ETH-ports and 0 USB-ports.
It is also known as the MQmaker AC1200 Wireless Gigabit Router Board. It also supports custom firmwares like: OpenWrt, LEDE Project
How to factory reset MQmaker WiTi Board - Default Login & Password

MQmaker WiTi Board default Password , Login & Gateway settings :

Default Gateway IP:
Default username: root
Default subnet mask:
Default DNS server:

How to factory reset (hard reset) MQmaker WiTi Board :

You can factory reset your MQmaker WiTi Board in the following way(s)
1. When the router is on, press the button reset and hold for 30 seconds.
2. While holding down the button reset, turn off the power of the router and hold down the button reset for 30 seconds
3. While holding down the button reset, turn on the power to the unit again and hold for another 30 seconds

MQmaker WiTi Board router specifications :

System specs
CPU: 880 MHz
RAM: 512 MiB
Flash: 16 MiB
Custom firmwares: OpenWrt, LEDE Project
WiFi: Gigabit (abgn+ac)
WiFi bands
WiFi throughput: n/a
2 x Gigabit ports
4 x Gigabit ports
USB-ports: 0
WiTi Board Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the MQmaker WiTi Board
Flashing OpenWrt on the MQmaker WiTi Board
The MQmaker WiTi Board is supported by OpenWrt according to their Table of
Hardware. So
flashing OpenWrt onto it should be quite straigthforward.
We couldn’t find any specific instructions for flashin OpenWrt on the MQmaker
WiTi Board, but since it’s listed in their Table of Hardware as supported, you can
over to the
OpenWrt install instructions and read on there.
Note: Flashing custom firmwares is always on you’re on own risk. Make sure to
read OpenWrt’s wikis to understand the risks and how to proceed if something goes
Flashing LEDE Project on the WiTi Board
The MQmaker WiTi Board is also supported by the LEDE Project.
To install LEDE aquire the correct firmware from their
Firmware downloads page and
then follow the instructions on their
Quick Start Guide
Note: Make sure to read the LEDE wikis carefully before flashing.