The PHICOMM K2P router has Gigabit WiFi, 4 Gigabit ETH-ports and 0 USB-ports. It also supports custom firmwares like: LEDE Project
PHICOMM K2P default Password , Login & Gateway settings :
Default Gateway IP: 192.168.2.1
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.2.1
How to factory reset (hard reset) PHICOMM K2P :
You can factory reset your PHICOMM K2P in the following way(s)
1. When the router is on, press the button reset and hold for 30 seconds.
2. While holding down the button reset, turn off the power of the router and hold down the button reset for 30 seconds
3. While holding down the button reset, turn on the power to the unit again and hold for another 30 seconds
PHICOMM K2P router specifications :
CPU: 880 MHz
RAM: 128 MiB
Flash: 16 MiB
Custom firmwares: LEDE Project
WiFi: Gigabit (abgn+ac)
WiFi throughput: n/a
1 x Gigabit port
4 x Gigabit ports
Staying up to date with the latest firmware is a good idea to keep your router even more
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the PHICOMM K2P
Flashing LEDE Project on the K2P
The PHICOMM K2P is also supported by the LEDE Project.
To install LEDE aquire the correct firmware from their
Firmware downloads page and
then follow the instructions on their
Quick Start Guide
Note: Make sure to read the LEDE wikis carefully before flashing.