TP-LINK TL-WR841ND v8.x default Password , Login & Gateway settings :
Default Gateway IP: 192.168.0.1
Default username: admin
Default password: admin
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.0.1
How to factory reset (hard reset) TP-LINK TL-WR841ND v8.x :
You can factory reset your TP-LINK TL-WR841ND v8.x in the following way(s)
Through the web interface
Open a browser and navigate to the web interface of the router (see default settings below)
In the menu look for System tools and under there find the Factory defaults option
On the Factory defaults page click on the Restore button to perform the reset.
With the RESET/WPS button
Have the unit powered on
Press and hold the reset (sometimes reset/WPS) button for 10 seconds with a paperclip or other sharp object.
When the SYS led start blinking quickly release the reset button and wait for router to boot back up.
How to login to the TP-LINK TL-WR841ND v8.x :
Make sure you are connected to the router’s network, either by Wi-Fi or ethernet cable.
Open your browser and visit
You should be prompted with a login dialogue.
Enter the username: admin
and the password admin
You will now be logged in. If you haven’t yet changed the defaul password, we recommend that you change it first
thing you do after logging in.
TP-LINK TL-WR841ND v8.x router specifications :
CPU: 500 MHz
RAM: 32 MiB
Flash: 4 MiB
Custom firmwares: OpenWrt
WiFi: 300mbps (bgn)
WiFi throughput: n/a
1 x 100mbps port
4 x 100mbps ports
TL-WR841ND v8.x Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the TP-LINK TL-WR841ND v8.x
Flashing OpenWrt on the TP-LINK TL-WR841ND v8.x
The TP-LINK TL-WR841ND v8.x is supported by OpenWrt according to their Table of
flashing OpenWrt onto it should be quite straigthforward.
We couldn’t find any specific instructions for flashin OpenWrt on the TP-LINK
TL-WR841ND v8.x, but since it’s listed in their Table of Hardware as supported, you can
over to the
OpenWrt install instructions and read on there.
Note: Flashing custom firmwares is always on you’re on own risk. Make sure to
read OpenWrt’s wikis to understand the risks and how to proceed if something goes
TP-LINK stock firmware for the TL-WR841ND v8.x
Stock firmwares for the TL-WR841ND v8.x are available under the download section on the
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.