The Belkin F5D7231-4P v1 router has 54mbps WiFi, 4 100mbps ETH-ports and 0 USB-ports.
It is also known as the Belkin Wireless G Plus Router with Built-In USB Print Server.
Belkin F5D7231-4P v1 default Password , Login & Gateway settings :
Default Gateway IP: 192.168.2.1
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.2.1
How to factory reset (hard reset) Belkin F5D7231-4P v1 :
You can factory reset your Belkin F5D7231-4P v1 in the following way(s)
1. When the router is on, press the button reset and hold for 30 seconds.
2. While holding down the button reset, turn off the power of the router and hold down the button reset for 30 seconds
3. While holding down the button reset, turn on the power to the unit again and hold for another 30 seconds
Belkin F5D7231-4P v1 router specifications :
CPU: 200 MHz
RAM: 16 MiB
Flash: 4 MiB
Custom firmwares: OpenWrt
WiFi: 54mbps (bg)
WiFi throughput: n/a
1 x 100mbps port
4 x 100mbps ports
F5D7231-4P v1 Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Belkin F5D7231-4P v1
Flashing OpenWrt on the Belkin F5D7231-4P v1
The Belkin F5D7231-4P v1 is supported by OpenWrt according to their Table of
flashing OpenWrt onto it should be quite straigthforward.
We couldn’t find any specific instructions for flashin OpenWrt on the Belkin
F5D7231-4P v1, but since it’s listed in their Table of Hardware as supported, you can
over to the
OpenWrt install instructions and read on there.
Note: Flashing custom firmwares is always on you’re on own risk. Make sure to
read OpenWrt’s wikis to understand the risks and how to proceed if something goes
Belkin stock firmware for the F5D7231-4P v1
Stock firmwares for the F5D7231-4P v1 are available under the download section on the
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.