How to factory reset Buffalo WLI3-TX1-G54 router – Default Login & Password

The Buffalo WLI3-TX1-G54 router has 54mbps WiFi, 1 100mbps ETH-ports and 0 USB-ports. It also supports custom firmwares like: dd-wrt, OpenWrt
How to factory reset Buffalo WLI3-TX1-G54 - Default Login & Password

Buffalo WLI3-TX1-G54 default Password , Login & Gateway settings :

If you have performed a reset of your WLI3-TX1-G54 device or not changed the defaults, you
should
be able to access it with the following settings
Default subnet mask: 255.255.255.0

How to factory reset (hard reset) Buffalo WLI3-TX1-G54 :

You can factory reset your Buffalo WLI3-TX1-G54 in the following way(s)
1. When the router is on, press the button reset and hold for 30 seconds.
2. While holding down the button reset, turn off the power of the router and hold down the button reset for 30 seconds
3. While holding down the button reset, turn on the power to the unit again and hold for another 30 seconds

Buffalo WLI3-TX1-G54 router specifications :

System specs
CPU: 200 MHz
RAM: 16 MiB
Flash: 4 MiB
Custom firmwares: dd-wrt, OpenWrt
Connectivity
WiFi: 54mbps (bg)
WiFi bands
2.4GHz
WiFi throughput: n/a
WAN
None
ETH
1 x 100mbps port
USB-ports: 0
WLI3-TX1-G54 Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
secure
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
flashing
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
increase
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Buffalo WLI3-TX1-G54
Flashing dd-wrt on the Buffalo WLI3-TX1-G54
Since the WLI3-TX1-G54 has 4 MiB of flash memory, you should choose a
stripped down version of dd-wrt that fits on the smaller flash.
We haven’t find any specific instructions for flashin dd-wrt onto the Buffalo
WLI3-TX1-G54, but you can read the
Installation guide over at dd-wrt to get a clue on how to proceed (As this model is listed as
supported).
Note: Always make sure to read the wiki and howtos of dd-wrt before doing any
flashing.
Flashing OpenWrt on the Buffalo WLI3-TX1-G54
The Buffalo WLI3-TX1-G54 is supported by OpenWrt according to their Table of
Hardware. So
flashing OpenWrt onto it should be quite straigthforward.
We couldn’t find any specific instructions for flashin OpenWrt on the Buffalo
WLI3-TX1-G54, but since it’s listed in their Table of Hardware as supported, you can
head
over to the
OpenWrt install instructions and read on there.
Note: Flashing custom firmwares is always on you’re on own risk. Make sure to
read OpenWrt’s wikis to understand the risks and how to proceed if something goes
wrong.

Buffalo