The D-Link DWL-900AP router has 11mbps WiFi, 1 10mbps ETH-ports and 0 USB-ports.
D-Link DWL-900AP default Password , Login & Gateway settings :
If you have performed a reset of your DWL-900AP device or not changed the defaults, you
should
be able to access it with the following settings
Default Network name (SSID): default
Default password: public
Default subnet mask: 255.255.255.0
How to factory reset (hard reset) D-Link DWL-900AP :
You can factory reset your D-Link DWL-900AP in the following way(s)
With the reset button
Locate the reset button on the back off the router
While the unit is powered on, press the reset button with a sharp object (e.g. paperclip)
Hold the button pressed for 10 seconds, then release.
The unit will reboot by itself and once the WLAN light stops blinking the factory reset is done.
You can now setup your router again through the user interface
D-Link DWL-900AP router specifications :
System specs
CPU: n/a
RAM: 0.5 MiB
Flash: 0.25 MiB
Custom firmwares: None
Connectivity
WiFi: 11mbps (b)
WiFi bands
2.4GHz
WiFi throughput: n/a
WAN
None
ETH
1 x 10mbps port
USB-ports: 0
DWL-900AP Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
secure
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
flashing
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
increase
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the D-Link DWL-900AP
D-Link stock firmware for the DWL-900AP
Stock firmwares for the DWL-900AP are available under the download section on the
modem’s
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.
