How to factory reset Netgear RAX40 (Nighthawk AX4) router – Default Login & Password

The Netgear RAX40 (Nighthawk AX4) router has Gigabit WiFi, 4 N/A ETH-ports and 0 USB-ports.
It is also known as the Netgear Nighthawk AX4 – AX3000 4-Stream WiFi Router.
How to factory reset Netgear RAX40 (Nighthawk AX4) - Default Login & Password

Netgear RAX40 (Nighthawk AX4) default Password , Login & Gateway settings :

If you have performed a reset of your RAX40 (Nighthawk AX4) device or not changed the defaults, you
should
be able to access it with the following settings
Default username: admin
Netgear router default password list
Default password: password
Default subnet mask: 255.255.255.0

How to factory reset (hard reset) Netgear RAX40 (Nighthawk AX4) :

You can factory reset your Netgear RAX40 (Nighthawk AX4) in the following way(s)
With the reset button
Have the router powered on (if just booted wait around one minute for it to load)
With a sharp pen or paper clip, press down the Restore Factory Settings button and hold it for about 7 seconds
When the power light starts to blink you can release the reset button and wait for the router to start up
The power light will be solid (not blinking) once the router is started.

Netgear RAX40 (Nighthawk AX4) router specifications :

System specs
CPU: 800 MHz
RAM: 512 MiB
Flash: 256 MiB
Custom firmwares: None
Connectivity
WiFi: Gigabit (abgn+ac+ax)
WiFi bands
n/a
WiFi throughput: n/a
WAN
1 x N/A port
ETH
4 x N/A ports
USB-ports: 0
RAX40 (Nighthawk AX4) Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
secure
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
flashing
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
increase
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Netgear RAX40 (Nighthawk AX4)
Netgear stock firmware for the RAX40 (Nighthawk AX4)
Stock firmwares for the RAX40 (Nighthawk AX4) are available under the download section on the
modem’s
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.

NetGear