The Netgear WNDAP620 router has 300mbps WiFi, 1 Gigabit ETH-ports and 0 USB-ports.
It is also known as the Netgear ProSafe 3×3 Single Radio, Dual Band Wireless-N Access Point.
Netgear WNDAP620 default Password , Login & Gateway settings :
Default Gateway IP: 192.168.0.100
Netgear login instructions
Default username: admin
Netgear router default password list
Default password: password
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.0.100
How to factory reset (hard reset) Netgear WNDAP620 :
You can factory reset your Netgear WNDAP620 in the following way(s)
With the reset button
Have the router powered on (if just booted wait around one minute for it to load)
With a sharp pen or paper clip, press down the Restore Factory Settings button and hold it for about 7 seconds
When the power light starts to blink you can release the reset button and wait for the router to start up
The power light will be solid (not blinking) once the router is started.
How to login to the Netgear WNDAP620 :
Make sure you are connected to the router’s network, either by Wi-Fi or ethernet cable.
Open your browser and visit
http://192.168.0.100
You should be prompted with a login dialogue.
Enter the username: admin
and the password password
You will now be logged in. If you haven’t yet changed the defaul password, we recommend that you change it first
thing you do after logging in.
Netgear WNDAP620 router specifications :
System specs
CPU: 1 GHz
RAM: 128 MiB
Flash: 32 MiB
Custom firmwares: OpenWrt
Connectivity
WiFi: 300mbps (abgn)
WiFi bands
2.4GHz & 5GHz
WiFi throughput: n/a
WAN
None
ETH
1 x Gigabit port
USB-ports: 0
