The Ubiquiti Networks UniFi AP router has 300mbps WiFi, 1 100mbps ETH-ports and 0 USB-ports. It also supports custom firmwares like: dd-wrt, OpenWrt
UniFi AP default Password , Login & Gateway settings :
If you have performed a reset of your UniFi AP device or not changed the defaults, you
should
be able to access it with the following settings
Default subnet mask: 255.255.255.0
How to factory reset (hard reset) UniFi AP :
You can factory reset your Ubiquiti Networks UniFi AP in the following way(s)
1. When the router is on, press the button reset and hold for 30 seconds.
2. While holding down the button reset, turn off the power of the router and hold down the button reset for 30 seconds
3. While holding down the button reset, turn on the power to the unit again and hold for another 30 seconds
UniFi AP router specifications :
System specs
CPU: 400 MHz
RAM: 64 MiB
Flash: 8 MiB
Custom firmwares: dd-wrt, OpenWrt
Connectivity
WiFi: 300mbps (bgn)
WiFi bands
2.4GHz
WiFi throughput: n/a
WAN
None
ETH
1 x 100mbps port
USB-ports: 0
Ubiquiti Networks UniFi AP review (quick overview)
Here is the quick comparison of how the Ubiquiti Networks UniFi AP compares to
other routers on our site
Average
35/100
Editor
90/100
WiFi
6/100
Hardware
10/100
Current price
$81.65
For a full list of routers and how they compare to the UniFi AP, check the
Router Buying Guide which will help you buy the most
price-competitive router.
UniFi AP Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
secure
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
flashing
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
increase
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Ubiquiti Networks UniFi AP
Flashing dd-wrt on the Ubiquiti Networks UniFi AP
We haven’t find any specific instructions for flashin dd-wrt onto the Ubiquiti Networks
UniFi AP, but you can read the
Installation guide over at dd-wrt to get a clue on how to proceed (As this model is listed as
supported).
Note: Always make sure to read the wiki and howtos of dd-wrt before doing any
flashing.
Flashing OpenWrt on the Ubiquiti Networks UniFi AP
The Ubiquiti Networks UniFi AP is supported by OpenWrt according to their Table of
Hardware. So
flashing OpenWrt onto it should be quite straigthforward.
We couldn’t find any specific instructions for flashin OpenWrt on the Ubiquiti Networks
UniFi AP, but since it’s listed in their Table of Hardware as supported, you can
head
over to the
OpenWrt install instructions and read on there.
Note: Flashing custom firmwares is always on you’re on own risk. Make sure to
read OpenWrt’s wikis to understand the risks and how to proceed if something goes
wrong.
