How to factory reset ZyXEL WAP6906 router – Default Login & Password

The ZyXEL WAP6906 router has Gigabit WiFi, 2 N/A ETH-ports and 0 USB-ports. It has a total combined WiFi throughput of 3800 Mpbs.
It is also known as the ZyXEL AC3800 Tri-Band WiFi Repeater.
How to factory reset ZyXEL WAP6906 - Default Login & Password

ZyXEL WAP6906 default Password , Login & Gateway settings :

Default Gateway IP: 192.168.1.5
ZyXEL login instructions
Default username: admin
ZyXEL router default password list
Default subnet mask: 255.255.255.0
Default DNS server: 192.168.1.5

How to factory reset (hard reset) ZyXEL WAP6906 :

You can factory reset your ZyXEL WAP6906 in the following way(s)
Through the web interface
Open web browser and go to the address of your router (check defaults below)
Log in with your username/password (default are below)
Under Maintenance, locate Backup/Restore and click it
Locate the section Factory defaults and click the reset button, if prompted click Ok
Wait for the router to reboot
With the reset button
Have the router plugged in and turned on
Locate the reset button which is marked reset and usually in a hole
With a paperclip or sharp pen, press and hold the reset button for 10 seconds until the SYS light starts to blink
If the SYS light doesn’t start to blink after 10 seconds
Keep holding the reset button pressed
Turn off the modem / unplug it
While still holding the reset button, start / plug in the router
After about 20 seconds, the Power or SYS light will start blinking rapidly
Release the reset button
When the light stops blinking and light up normally the router is reset.

How to login to the ZyXEL WAP6906 :

Make sure you are connected to the router’s network, either by Wi-Fi or ethernet cable.
Open your browser and visit
http://192.168.1.5
You should be prompted with a login dialogue.
Enter the username: admin
and if it requires a password, leave it empty or try with admin / password
You will now be logged in. If you haven’t yet changed the defaul password, we recommend that you change it first
thing you do after logging in.

ZyXEL WAP6906 router specifications :

System specs
CPU: n/a
RAM: 128 MiB + 128 MiB
Flash: 16 MiB + 16 MiB
Custom firmwares: None
Connectivity
WiFi: Gigabit (abgn+ac)
WiFi bands
n/a
WiFi throughput: 3800 Mpbs
WAN
None
ETH
2 x N/A ports
USB-ports: 0
WAP6906 Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
secure
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
flashing
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
increase
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the ZyXEL WAP6906
ZyXEL stock firmware for the WAP6906
Stock firmwares for the WAP6906 are available under the download section on the
modem’s
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.