The ZyXEL WSR30 router has Gigabit WiFi, 1 N/A ETH-ports and 0 USB-ports. It has a total combined WiFi throughput of 2100 Mpbs.
It is also known as the ZyXEL Multy U AC2100 Tri-Band WiFi System.
ZyXEL WSR30 default Password , Login & Gateway settings :
If you have performed a reset of your WSR30 device or not changed the defaults, you
be able to access it with the following settings
Default subnet mask: 255.255.255.0
How to factory reset (hard reset) ZyXEL WSR30 :
You can factory reset your ZyXEL WSR30 in the following way(s)
Through the web interface
Open web browser and go to the address of your router (check defaults below)
Log in with your username/password (default are below)
Under Maintenance, locate Backup/Restore and click it
Locate the section Factory defaults and click the reset button, if prompted click Ok
Wait for the router to reboot
With the reset button
Have the router plugged in and turned on
Locate the reset button which is marked reset and usually in a hole
With a paperclip or sharp pen, press and hold the reset button for 10 seconds until the SYS light starts to blink
If the SYS light doesn’t start to blink after 10 seconds
Keep holding the reset button pressed
Turn off the modem / unplug it
While still holding the reset button, start / plug in the router
After about 20 seconds, the Power or SYS light will start blinking rapidly
Release the reset button
When the light stops blinking and light up normally the router is reset.
ZyXEL WSR30 router specifications :
CPU: 1 GHz
RAM: 256 MiB
Flash: 512 MiB
Custom firmwares: None
WiFi: Gigabit (abgn+ac)
2.4GHz & 5GHz
WiFi throughput: 2100 Mpbs
1 x N/A port
1 x N/A port
Staying up to date with the latest firmware is a good idea to keep your router even more
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the ZyXEL WSR30
ZyXEL stock firmware for the WSR30
Stock firmwares for the WSR30 are available under the download section on the
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.