The Buffalo WZR-HP-G450H router has 300mbps WiFi, 4 Gigabit ETH-ports and 0 USB-ports. It also supports custom firmwares like: dd-wrt, OpenWrt
Buffalo WZR-HP-G450H default Password , Login & Gateway settings :
If you have performed a reset of your WZR-HP-G450H device or not changed the defaults, you
be able to access it with the following settings
Default subnet mask: 255.255.255.0
How to factory reset (hard reset) Buffalo WZR-HP-G450H :
You can factory reset your Buffalo WZR-HP-G450H in the following way(s)
1. When the router is on, press the button reset and hold for 30 seconds.
2. While holding down the button reset, turn off the power of the router and hold down the button reset for 30 seconds
3. While holding down the button reset, turn on the power to the unit again and hold for another 30 seconds
Buffalo WZR-HP-G450H router specifications :
CPU: 400 MHz
RAM: 64 MiB
Flash: 32 MiB
Custom firmwares: dd-wrt, OpenWrt
WiFi: 300mbps (bgn)
WiFi throughput: n/a
1 x Gigabit port
4 x Gigabit ports
Staying up to date with the latest firmware is a good idea to keep your router even more
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Buffalo WZR-HP-G450H
Flashing dd-wrt on the Buffalo WZR-HP-G450H
Since the WZR-HP-G450H has 32 MiB of flash memory, you should be able to
dd-wrt with full functionality without having to worry too much about which firmware
We haven’t find any specific instructions for flashin dd-wrt onto the Buffalo
WZR-HP-G450H, but you can read the
Installation guide over at dd-wrt to get a clue on how to proceed (As this model is listed as
Note: Always make sure to read the wiki and howtos of dd-wrt before doing any
Flashing OpenWrt on the Buffalo WZR-HP-G450H
The Buffalo WZR-HP-G450H is supported by OpenWrt according to their Table of
flashing OpenWrt onto it should be quite straigthforward.
We couldn’t find any specific instructions for flashin OpenWrt on the Buffalo
WZR-HP-G450H, but since it’s listed in their Table of Hardware as supported, you can
over to the
OpenWrt install instructions and read on there.
Note: Flashing custom firmwares is always on you’re on own risk. Make sure to
read OpenWrt’s wikis to understand the risks and how to proceed if something goes