The Netgear Arlo Bridge (ABB1000) router has 300mbps WiFi, N/A ETH-ports and 0 USB-ports.
Netgear Arlo Bridge (ABB1000) default Password , Login & Gateway settings :
If you have performed a reset of your Arlo Bridge (ABB1000) device or not changed the defaults, you
should
be able to access it with the following settings
Default subnet mask: 255.255.255.0
How to factory reset (hard reset) Netgear Arlo Bridge (ABB1000) :
You can factory reset your Netgear Arlo Bridge (ABB1000) in the following way(s)
With the reset button
Have the router powered on (if just booted wait around one minute for it to load)
With a sharp pen or paper clip, press down the Restore Factory Settings button and hold it for about 7 seconds
When the power light starts to blink you can release the reset button and wait for the router to start up
The power light will be solid (not blinking) once the router is started.
Netgear Arlo Bridge (ABB1000) router specifications :
System specs
CPU: n/a
RAM: n/a
Flash: n/a
Custom firmwares: None
Connectivity
WiFi: 300mbps (bgn)
WiFi bands
2.4GHz
WiFi throughput: n/a
WAN
None
ETH
None
USB-ports: 0
