The Netgear EAX80 (Nighthawk AX8) router has Gigabit WiFi, 4 N/A ETH-ports and 0 USB-ports.
It is also known as the Netgear Nighthawk AX8 8-Stream Mesh Extender.
Netgear EAX80 (Nighthawk AX8) default Password , Login & Gateway settings :
If you have performed a reset of your EAX80 (Nighthawk AX8) device or not changed the defaults, you
be able to access it with the following settings
Default subnet mask: 255.255.255.0
How to factory reset (hard reset) Netgear EAX80 (Nighthawk AX8) :
You can factory reset your Netgear EAX80 (Nighthawk AX8) in the following way(s)
With the reset button
Have the router powered on (if just booted wait around one minute for it to load)
With a sharp pen or paper clip, press down the Restore Factory Settings button and hold it for about 7 seconds
When the power light starts to blink you can release the reset button and wait for the router to start up
The power light will be solid (not blinking) once the router is started.
Netgear EAX80 (Nighthawk AX8) router specifications :
CPU: 1.8 GHz
Custom firmwares: None
WiFi: Gigabit (abgn+ac+ax)
WiFi throughput: n/a
4 x N/A ports
EAX80 (Nighthawk AX8) Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Netgear EAX80 (Nighthawk AX8)
Netgear stock firmware for the EAX80 (Nighthawk AX8)
Stock firmwares for the EAX80 (Nighthawk AX8) are available under the download section on the
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.