The Netgear EX3800 router has Gigabit WiFi, 1 100mbps ETH-ports and 0 USB-ports.
It is also known as the Netgear AC 750 WiFi Range Extender – Essentials Edition. It also supports custom firmwares like: LEDE Project
Netgear EX3800 default Password , Login & Gateway settings :
If you have performed a reset of your EX3800 device or not changed the defaults, you
be able to access it with the following settings
Default subnet mask: 255.255.255.0
How to factory reset (hard reset) Netgear EX3800 :
You can factory reset your Netgear EX3800 in the following way(s)
With the reset button
Have the router powered on (if just booted wait around one minute for it to load)
With a sharp pen or paper clip, press down the Restore Factory Settings button and hold it for about 7 seconds
When the power light starts to blink you can release the reset button and wait for the router to start up
The power light will be solid (not blinking) once the router is started.
Netgear EX3800 router specifications :
CPU: 580 MHz
RAM: 64 MiB
Flash: 8 MiB
Custom firmwares: LEDE Project
WiFi: Gigabit (abgn+ac)
2.4GHz & 5GHz
WiFi throughput: n/a
1 x 100mbps port
Staying up to date with the latest firmware is a good idea to keep your router even more
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Netgear EX3800
Flashing LEDE Project on the EX3800
The Netgear EX3800 is also supported by the LEDE Project.
To install LEDE aquire the correct firmware from their
Firmware downloads page and
then follow the instructions on their
Quick Start Guide
Note: Make sure to read the LEDE wikis carefully before flashing.