The Netgear Nighthawk M1 (MR1100) router has Gigabit WiFi, 1 N/A ETH-ports and 0 USB-ports.
It is also known as the Netgear Nighthawk M1 – 4Gx Gigabit LTE Mobile Router.
Netgear Nighthawk M1 (MR1100) default Password , Login & Gateway settings :
If you have performed a reset of your Nighthawk M1 (MR1100) device or not changed the defaults, you
be able to access it with the following settings
Default subnet mask: 255.255.255.0
How to factory reset (hard reset) Netgear Nighthawk M1 (MR1100) :
You can factory reset your Netgear Nighthawk M1 (MR1100) in the following way(s)
With the reset button
Have the router powered on (if just booted wait around one minute for it to load)
With a sharp pen or paper clip, press down the Restore Factory Settings button and hold it for about 7 seconds
When the power light starts to blink you can release the reset button and wait for the router to start up
The power light will be solid (not blinking) once the router is started.
Netgear Nighthawk M1 (MR1100) router specifications :
RAM: 512 MiB
Flash: 512 MiB
Custom firmwares: None
WiFi: Gigabit (abgn+ac)
WiFi throughput: n/a
1 x N/A port
Nighthawk M1 (MR1100) Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the Netgear Nighthawk M1 (MR1100)
Netgear stock firmware for the Nighthawk M1 (MR1100)
Stock firmwares for the Nighthawk M1 (MR1100) are available under the download section on the
support page. You can also refer
to the router’s manual for instructions on how to upgrade the firmware.