How to factory reset Netgear Orbi Cable Router (CBR40) router – Default Login & Password

The Netgear Orbi Cable Router (CBR40) router has Gigabit WiFi, 4 Gigabit ETH-ports and 0 USB-ports. It has a total combined WiFi throughput of 2200 Mpbs.
How to factory reset Netgear Orbi Cable Router (CBR40) - Default Login & Password

Netgear Orbi Cable Router (CBR40) default Password , Login & Gateway settings :

If you have performed a reset of your Orbi Cable Router (CBR40) device or not changed the defaults, you
should
be able to access it with the following settings
Default username: admin
Netgear router default password list
Default password: password
Default subnet mask: 255.255.255.0

How to factory reset (hard reset) Netgear Orbi Cable Router (CBR40) :

You can factory reset your Netgear Orbi Cable Router (CBR40) in the following way(s)
With the reset button
Have the router powered on (if just booted wait around one minute for it to load)
With a sharp pen or paper clip, press down the Restore Factory Settings button and hold it for about 7 seconds
When the power light starts to blink you can release the reset button and wait for the router to start up
The power light will be solid (not blinking) once the router is started.

Netgear Orbi Cable Router (CBR40) router specifications :

System specs
CPU: 600 MHz + 716 MHz
RAM: 128 MiB + 512 MiB
Flash: 128 MiB + 256 MiB
Custom firmwares: None
Connectivity
WiFi: Gigabit (abgn+ac)
WiFi bands
2.4GHz & 5GHz
WiFi throughput: 2200 Mpbs
WAN
None
ETH
4 x Gigabit ports
USB-ports: 0

NetGear