How to factory reset TRENDnet TEW-411BRP router – Default Login & Password

The TRENDnet TEW-411BRP router has 54mbps WiFi, 4 100mbps ETH-ports and 0 USB-ports. It also supports custom firmwares like: dd-wrt
How to factory reset TRENDnet TEW-411BRP - Default Login & Password

TRENDnet TEW-411BRP default Password , Login & Gateway settings :

If you have performed a reset of your TEW-411BRP device or not changed the defaults, you
should
be able to access it with the following settings
Default subnet mask: 255.255.255.0

How to factory reset (hard reset) TRENDnet TEW-411BRP :

You can factory reset your TRENDnet TEW-411BRP in the following way(s)
With the reset button
Have the unit plugged in and powered on
Press and hold the reset button for 15 seconds (use a sharp pencil or a paperclip)
Wait for the router to reboot

TRENDnet TEW-411BRP router specifications :

System specs
CPU: 125 MHz
RAM: 16 MiB
Flash: 4 MiB
Custom firmwares: dd-wrt
Connectivity
WiFi: 54mbps (bg)
WiFi bands
2.4GHz
WiFi throughput: n/a
WAN
1 x 100mbps port
ETH
4 x 100mbps ports
USB-ports: 0
TEW-411BRP Firmwares
Staying up to date with the latest firmware is a good idea to keep your router even more
secure
from various security flaws.
If you want to squeeze a little bit of extra functionality out of your router, consider
flashing
an open-source firmware like dd-wrt, openWRT or LEDE. Flashing a custom ROM can greatly
increase
the stability and functionality of your old router.
Following are the firmwares that we have identified existing for the TRENDnet TEW-411BRP
Flashing dd-wrt on the TRENDnet TEW-411BRP
Since the TEW-411BRP has 4 MiB of flash memory, you should choose a
stripped down version of dd-wrt that fits on the smaller flash.
We haven’t find any specific instructions for flashin dd-wrt onto the TRENDnet
TEW-411BRP, but you can read the
Installation guide over at dd-wrt to get a clue on how to proceed (As this model is listed as
supported).
Note: Always make sure to read the wiki and howtos of dd-wrt before doing any
flashing.

TRENDnet